DECLAN INDUSTRIES INC.
Our Stellite® Tipped band saws, have a tip welded directly to the saw tooth. The tip is then annealed before going to the profile grinding process to match the shape of the tip to the required profile of the tooth. After all of the teeth have been profile ground, the saw then goes to a side grinding machine to grind the sides of the tips to specific relief angles and kerf size depending upon the given cutting application for the saw.
We manufacture and re-tip wide band saws (3"-12"wide). We also manufacture and re-tip circular saws (12"-36"dia.) Our band saws and circular saws can be tipped to meet your unique requirements. Contact us to discuss your application and your needs for Stellite® tipped saws.
Stellite® tipped saws have shown to be able to:
•Increase run times.
•Cut with thinner kerf.
•Produce a smoother sawn surface.
•Reduce sawing variations - Better cutting accuracy. (allowing for tighter target sizes)
•Reduce the power consumption during cutting.
•Reduce the cutting downtime for saw changes and saw maintenance.
•Increased saw life due to the ability to achieve more sharpenings and at longer intervals.
Stellite® is also more resistant to the abrasive acids found in some woods like red cedar. This allows the tips to stay sharp longer than carbide tips and significantly longer than swaged saw steel when cutting unseasoned woods.
Stellite is a registered trademark of Deloro Stellite Inc.
Please phone or e-mail for pricing or information.
Send mail to
questions or comments about this web site.